MWI was not tested, as a local voice mail system was not available on the PBXs at the time of testing. Aside from Transfers or Conferences, it is not possible to put a call on hold from one of the Siemens HiPath/Hicom digital station phones. The call is held automatically during Transfers or Conferences, and the call hold is facilitated in NOTIFY message from Siemens HiPath/Hicom PBX. However, the Called Name/Number of the forwarding phone were not passed to the final destination phone, nor were the Connected Name/Number updated at the originating phone to reflect the name/number of the final destination.Ĭall Hold was not tested as a separate feature.
On Conference Calls, the Connected Name/Number was not updated on the originating phone display when a conferee dropped out.Īll Call Forward scenarios that were originated by a Network/External (i.e., not Local) call resulted in dropped calls.Ĭall Forward scenarios that were originated by a Local call resulted in successful call completion, and the original Calling Name/Number were successfully passed to the final destination phone.
(2) Siemens Hicom digital station telephonesĬisco IOS voice gateways: Cisco IOS Release Version 12.3(11) or later.Īll Call Transfers resulted in dropped calls.Īll Call Conference scenarios resulted in dropped calls if certain parties dropped out of the conference. (2) Siemens HiPath digital station telephones (2) Cisco IOS voice gateways with E1 VWICs (voice/WAN interface cards) Important notices, privacy statements, and trademarks of Cisco Systems, Inc. If these Supplementary Services are needed, it is recommended that MGCP or H.323 be used as the connection between the Cisco IOS gateways.Ģ007 Cisco Systems, Inc. Supplementary services, including Call transfer, Call Conference, Call Forward, and Called Name/Number were not supported for the SIP toll bypass implementation. Using the Siemens PBX configurations and Cisco IOS voice gateway configurations in this application note, successful toll bypass integration was achieved for basic calls and Calling Name/Number. End-to-end calls were placed between the PBXs to exercise and test basic calls as well as QSIG supplementary services such as call transfer, call conference, and call forward. The two voice gateways were connected via IP over Ethernet, and configured for VoIP using SIP. The Cisco IOS voice gateways extend the E1 QSIG trunk circuits with VoIP, using the SIP protocol.Ī Siemens HiPath 4000 Release 1 PBX and a Siemens Hicom 330E Release 3.1 PBX were each connected via E1 QSIG trunk circuits a Cisco IOS voice gateway. The PBXs are connected to the Cisco IOS voice gateways by E1 QSIG trunk circuits.
This application note provides configuration guidelines for a toll-bypass network using Cisco IOS voice gateways to connect Siemens HiPath 4000 Release 1 and Siemens Hicom 330E Release 3.1 PBXs.
#SIEMENS HIPATH 3800 REMOVE CALL FORWARDING. SERIES#
40Īlthough specific gateway router models were used to validate its content, this application note also applies to all Cisco 1700/2600/3600/3700/2800/3800 series Cisco IOS voice gateways. Siemens HiPath 4000 Release 1 and Siemens Hicom 330E Release 3.1 to Cisco IOS Voice Gateway using E1 QSIG with SIP
0 kommentar(er)
